RCA ANT1150F Manuel d'utilisateur télécharger pdf (Page 7)

English

To remove the antenna (and mounting strips) from the

wall:

1. Hold the antenna against the wall gently to keep it in

place. DO NOT press the antenna against wall.

2. Find the tab for the single mounting strip at the bottom

of the antenna (on the metal part). Stretch the tab

straight down (away from the antenna) at least 12 inches

until the strip releases.

Important: NEVER pull the strip tab towards you.

3. Pull the antenna off the wall slightly so that you can

reach the tabs for the two mounting strips at the top of

the antenna. Repeat step 2 for each of these tabs as well.

Note: If you can’t reach the tabs, you can remove the antenna

from the mounting strips using a piece of dental ﬂoss. Gently run

the ﬂoss behind the antenna, between the strips and the antenna,

until the strips separate. Then perform step 2 above for each of

the strips by themselves.

4. Remove the mounting strips from the antenna.

If you want to mount the antenna to the wall again, you

can ﬁnd replacement strips at most retail or drug stores.

4. Remove the black liner for each strip.

5. Line up the antenna where you want to put it, then press it against the wall for 10

seconds.

6. Stop pressing the antenna against the wall and conﬁrm that it’s ﬁrmly attached to the

wall. Then press an additional 30 seconds.

Important: The mounting strips have tabs that extend beyond the borders of the adhesive. Leave

these in place--they will allow you to remove the antenna without damaging your wall.

To mount the antenna using thumbtacks

(not included):

Insert two thumbtacks (not included) into

the two holes on the top of the antenna.

Hold the thumbtacks in place and lower the

holes onto the thumbtacks. Make sure to line

up the holes with the thumbtacks.

1 2 3 4 5 6 7 8

Pas de commentaire

RCA ANT1150F Manuel d'utilisateur Page 7