Rca M50WH92S Manuel d'utilisateur télécharger pdf (Page 25)

Chapter 2 25

Using the Remote Control

Volume Punchthrough Feature

You may ﬁnd this feature helpful if you’ve connected your devices to an audio system, and you

want to use the TV’s remote control to operate the volume for a device that is connected to the

audio system. An example follows:

Let’s say you’ve connected your DVD player to your audio system. You’ve also programmed your

TV remote control to operate your DVD player. Since the DVD player sends its volume through

the audio system, you would have to bounce back and forth between two remote controls: the

audio system’s remote to adjust the volume and the TV’s remote control to operate the DVD

player.

The Volume Punchthrough feature eliminates the need for you to use two remote controls and

saves a button press when you’re using the TV remote to adjust the volume. In effect, you are

telling the TV remote to retrieve and send volume commands from the audio system whenever

the TV remote is in DVD mode.

Therefore, after you’ve successfully set up the Volume Punchthrough feature, whenever the TV

remote is in DVD mode (press the DVD button) and you want to adjust the volume, you only

have to press the VOL +/- or MUTE buttons. Follow the instructions below to set up Volume

Punchthrough.

1. On your remote control, simultaneously press and hold the ON•OFF and MUTE buttons

(approximately 3 seconds) until a device button remains lit. Then release the buttons.

2. Press and hold the MUTE button until the device button blinks off, then release the MUTE

button.

3. Press and release the device button that you programmed to operate the audio system

(receiver or ampliﬁer).

4. Press and release the MUTE button.

5. Now, test it by turning on your audio system.

6. Turn on the device that is connected to the audio system (satellite receiver, for example).

7. Put the TV’s remote in SAT•AUX mode by pressing the SAT•AUX button.

8. Press VOL+ or VOL-. The volume from the audio system should increase or decrease

accordingly.

Deleting ALL Volume Punchthrough Commands

To delete all programmed Volume Punchthrough settings and return the remote control back to

the factory default:

1. Simultaneously press and hold the ON•OFF and MUTE buttons (approximately 3 seconds)

until a device button remains lit. Then release the buttons.

2. Press and hold the MUTE button until the device button blinks off, then release the MUTE

button.

3. Press and release the MUTE button.

4. The remote returns to normal Volume/Mute control.

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 63 64

Pas de commentaire

Rca M50WH92S Manuel d'utilisateur Page 25