Rca SPS3200 Manuel d'utilisateur télécharger pdf

WARNING: TO REDUCE THE RISK OF FIRE OR

ELE CTR IC SHO CK, DO NO T REM OVE CO VER (O R

BACK). NO USER-SERVICEABLE PARTS INSIDE. REFER

SERVICING TO QUALIFIED SERVICE PERSONNEL.

WARNING: TO PREVENT FIRE OR SHOCK HAZARD,

D O NO T E X POS E T H I S A P PL I A NC E T O R A I N O R

MOISTURE.

Some of the following information may not apply to your

particular product; however, as with any electronic product,

precautions should be observed during handling and use.

Read these instructions.•

Keep these instructions.•

Heed all warnings.•

Follow all instructions.•

Do not use this apparatus near water.•

Clean only with a dry cloth.•

Do not block any ventilation openings. Install in accordance •

with the manufacturer’s instructions.

Do not install near any heat sources such as radiators, heat •

registers, stoves, or other apparatus (Including ampliers)

that produce heat.

Do not defect the safety purpose of the polarized or •

grounding-type plug. A polarized plug has two blades with

one wider than the other. A grounding type plug has two

blades and a third grounding prong. The wide blade or the

third prong is provided for your safety.

If the provided plug does not t into your wall outlet, consult

an electrician for replacement of the obsolete outlet.

Protect the power cord from being walked on or pinched •

particularly at plugs, convenience receptacles, and the point

where they exit from the apparatus.

Only use attachments / accessories specified by the •

manufacturer.

Use only with a cart, stand, tripod, bracket, or •

table specied by the manufacturer, or sold with

the apparatus. When a cart is used, use caution

Useful Advice

Do not use your system immediately after transporting it •

from a cold place to a warm place, as condensation may

cause the system to malfunction. If moisture forms inside

this system, it may not operate properly. To correct the

problem, turn off the power and wait about 30 minutes for

moisture to evaporate.

This system is tted with a laser. To avoid accidents, it is to •

be opened by qualied technicians only.

Never leave the tray open as dust could cover the laser lens •

and / or the tray could be bumped into accidentally.

Do not palce the system near wet areas such as bathrooms •

and pool inside. Avoid storing the system at humid places or

near abnormally heated areas.

Ensure minimum distance around the apparatus for •

sufcient ventilation. The ventilation should not be impeded

by covering the ventilation openings with items, such as

newspaper, etc.

No naked ame source, such as lighted candles, should be •

placed on the apparatus.

Before You Begin

Mounting Instructions

TOOLS NEEDED:

1) Electric drill with 1/4” bit;

2) Phillips-head (cross style) Screwdriver.

STEP 1

If your cabinet does NOT have an overhang:

a) Place the Mounting Template in the desired location inside

or underneath the cabinet (whichever has less obstructions,

and will be easier for you to reach to drill holes), ush with

the front edge of the cabinet and tape it down. Go to STEP 2.

If your cabinet DOES have an overhang:

a) Measure the thickness of the cabinet overhang (see Figure

1).

b) Fold the Mounting Template along the guideline that is

closest to the thickness (see dimension "T" in illustration) of

your cabinet overhang.

Figure 1

STEP 3

If your cabinet does NOT have an overhang:

a) Four screws are provided with the unit. Select the screw

length which will go completely through your cabinet bottom,

and provide at least 3/8" of thread to screw into the main

unit.

b) Insert the four selected screws through each hole from the

inside of the cabinet going down (see Figure 4).

Figure 2

Figure 3

Figure 4

General Controls

Front Panel Controls

1. CD Drawer

2. LCD Display

POWER Button

Press to turn ON the unit or put it in STANDBY(OFF) mode.

PLAY/PAUSE Button

Press to start / pause playback of a disc.

STOP Button

Press to stop playing a disc.

PREV/- TUNE

Button

Press to change the digits(in Timer mode) / skip to the

previous track(in CD mode) / tune in to different stations(in

Radio mode).

NEXT/TUNE +

Button

Press to change the digits(in Timer mode) / skip to the next

track(in CD mode) / tune in to different stations(in Radio

mode).

8. VOLUME -/+ Button

Press to adjust the volume.

WARNING: T HE A PPA R AT US S HAL L N OT BE

EXPOSED TO DRIPPING OR SPLASHING AND THAT NO

OBJECTS FILLED WITH LIQUIDS, SUCH AS VASES, SHALL

BE PLACED ON THE APPARATUS.

CAUTION:

U S E O F C O N T R O L S O R A D J U S T M E N T S O R •

PERFORMANCE OF PROCEDURES OTHER THAN

THOSE SPECIFIED MAY RESULT IN HAZARDOUS

RADIATION EXPOSURE.

MAIN PLUG IS USED AS THE DISCONNECTED DEVICE, •

IT SHALL REMAIN OPERABLE AND SHOULD NOT

BE OBSTRUCTED DURING

INTENDED USE. TO BE

COMPLETELY DISCONNECTED THE APPARATUS

FROM

SUPPLY MAINS, THE MAIN PLUG OF THE APPARATUS

SHALL

BE DISCONNECTED FROM THE MAINS SOCKET

OUTLET COMPLETELY.

ON SAFETY

Before operating, make sure the voltage requirement of the •

mains plug matches your local voltage.

Disconnect the mains plug immediately if liquid spills into •

or onto the unit, or if an object falls into the unit. The unit

should not be used until service by a qualified service

personnel is completed.

Do not open the cabinet. Lasers used in rays employed by •

the unit may damage your eyes. Any servicing should be

done by qualied service personnel.

When you are not going to use the unit for a long period of •

time, disconnect the mains plug.

The symbol for Class II

(Double Insulation)

The lightning ash with an arrowhead symbol, within the

equilateral triangle, is intended to alert the user to the

presence of uninsulated "dangerous voltage" within the

product's enclosure that may be of sufcient magnitude

to cause an electric shock.

The exclamation point within the equilateral triangle is

intended to alert the user to the presence of important

operating and maintenance (servicing) instructions in this

owner’s manual.

For your safety

The AC power plug is polarized (one blade is

wider than the other) and only fits into AC power

outlets one way. If the plug won't go into the outlet

completely, turn the plug over and try to insert it

the other way. If it still won't t, contact a qualied electrician

to change the outlet, or use a different one. Do not attempt to

bypass this safety feature.

Removing the power supply is the only way to completely

remove power from your product. Make sure the power plug

remains easily accessible.

CAUTION: TO PREVENT ELECTRIC SHOCK, MATCH WIDE

BLADE OF PLUG TO WIDE SLOT, THEN FULLY INSERT.

V1.0 (EN)

User Manual

SPS3200

It's important to read this instruction prior to using your new product for the

rst time.

Safety Precautions

FCC Information

STEP 2

Use an electric drill with a ¼” bit (not included) to drill all four

holes marked on the Mounting Template (see Figure 3). To

reduce splintering, place a small piece of masking tape over

each hole location before drilling.

Go to STEP 3.

Important Safety Instructions

Safety Precautions

If your cabinet DOES have an overhang:

a) Four screws are provided with the unit. Select the screw

length which will go completely through your cabinet bottom,

and extend at least will go completely through your cabinet

bottom, and extend at least 3/8" past the bottom of your

cabinet overhang.

b) This unit includes two sets of four spacers of various lengths.

The spacers can be put together to form longer spacers

to accommodate various cabinet overhang thicknesses.

Determine the best combination of spacers which is equal to

or longer than the cabinet overhang thickness.

c) Insert the four selected screws through each hole from the

inside of the cabinet going down (see Figure 5).

OPEN/CLOSE Button

Press to open / close the CD door.

10. AM/FM Band Button

11. CD·RADIO Button

12.

REPEAT/PRESET Button

Press to repeat a single track or an entire disc(in CD mode)

/ set a radio station preset(in Radio mode).

13.

CLOCK SET/MEM Button

Press to set a clock(in standby mode) / store a track in

memory(in CD stop mode).

14. TIMER Button

Press to set the cooking timer.

15. Display Button

Portable Cart

Warning

SEE MARKING ON BACK OF PRODUCT

ON PLACEMENT

Do not leave, mount or use the unit in places which are •

extremely hot, cold, dusty, or humid.

Allow adequate air circulation to prevent internal heat build-•

up. Do not place the unit on a surface or near materials (a

curtain ex. rugs, blankets, curtains, etc.) which might block

the ventilation holes.

ON CONDENSATION

When left in a heated room where it is warm and damp, •

water droplets or condensation may form inside the CD

player. When there is condensation inside the unit, the

unit may not function normally. Let it stand for 1 to 2 hours

before turning the power on, or gradually heat the room and

allow the unit to dry before use.

when moving the cart /apparatus combination to avoid injury

from tip-over.

Unplug this apparatus during lightning storms or when •

unused for long periods of time.

Refer all servicing to qualied service personnel. Servicing •

is required when the apparatus has been damaged in any

way, such as the power cord or plug is damaged, liquid has

been spilled or objects have fallen into the apparatus, the

apparatus has been exposed to rain or moisture, does not

operate normally, or has been dropped.

Important Battery Precautions

Any battery may may present a risk of fire, explosion, or •

chemical burn if abused. Do not try to charge a battery that

is not intended to be recharged, do not incinerate, and do

not puncture.

Non-rechargeable batteries, such as alkaline batteries, may •

leak if left in your product for a long period of time. Remove

the batteries from the product if you are not going to use it

for a month or more.

Discard any leaky or deformed battery immediately. They •

may cause skin burns or other personal injury.

Batteries shall not be exposed to excessive heat such as •

sunshine, re or the like.

Please help to protect the environment by recycling or •

disposing of batteries according to federal, state, and local

regulations.

This device complies with part 15 of the FCC Rules. Operation

is subject to the following two conditions: (1) This device may

not cause harmful interference, and (2) this device must accept

any interference received, including interference that may

cause undesired operation.

This equipment has been tested and found to comply with

the limits for a Class B digital device, pursuant to part 15

of the FCC Rules. These limits are designed to provide

reasonable protection against harmful interference in a

residential installation. This equipment generates, uses and

can radiate radio frequency energy and, if not installed and

used in accordance with the instructions, may cause harmful

interference to radio communications.

However, there is no guarantee that interference will not occur

in a particular installation. If this equipment does cause harmful

interference to radio or television reception, which can be

determined by turning the equipment off and on, the user is

encouraged to try to correct the interference by one or more of

the following measures:

Reorient or relocate the receiving antenna.•

Increase the separation between the equipment and receiver.•

Connect the equipment into an outlet on a circuit different •

from that to which the receiver is connected.

Consult the dealer or an experienced radio / TV technician •

for help.

WARNING: Changes or modications to this unit not expressly

approved by the party responsible for compliance could void

the user's authority to operate the equipment.

This Class B digital apparatus complies with Canadian ICES-

003.

This product complies with DHHS Rules 21 CFR Subchapter J.

Applicable at the date of manufacture.

b) Plug the power cord directly into the nearest wall outlet, and

wrap the remaining cord around the cord storage knob at

the rear of the unit.

MOUNTING SUGGESTIONS

1) If your cabinet has obstructions inside it which prevent you

from using the template, cut out the corresponding area on

the template, but do NOT cut out or through the screw holes.

2) If your cabinet has obstructions underneath it, which

will interfere with the mounting of the unit, remove the

obstruction before mounting the unit, or nd another location

to mount the unit.

3) It is recommended that you wear safety glasses while drilling

to prevent eye injuries.

4) For wood cabinets, you may want to mark the hole locations

with a nail, pressed gently but rmly into the wood so that a

slight impression is made. This will also help keep the drill

bit centered in the right location.

5) Hold the drill rmly against the cabinet to keep the drill from

“walking”.

CAUTION:

TO REDUCE THE RISK OF FIRE, DO NOT PLACE ANY

HEATING OR COOKING APPARATUS BENEATH THIS

UNIT.

d) Hold each screw head down and push the unit and spacers

onto the screws, then hold the unit up until spacers are

firmly against the bottom of the cabinet (and fully nested

within each other if you are using multiple spacers for each

screw).

e) Partially tighten each screw, but do not fully tighten the

screws until all of them have been started (see Figure 6).

f) Gently tighten each screw until they are rmly holding the

unit in place. The top front edge of the unit should clear the

overhang.

Go to STEP 4.

Figure 6

Mounting

Screw

c) Tape Mounting Template to the underside of the cabinet with

the folded portion of the Mounting Template ush up against

the cabinet overhang (see Figure 2). Go to STEP 2.

c) Hold the unit up against the bottom of the cabinet, and align

the four holes on the top of the unit with the screws. Partially

tighten each screw, but do not fully tighten the screws until

all of them have been started.

d) Gently tighten each screw until they are rmly holding the

unit in place.

Go to STEP 4.

Figure 5

Mounting

Screw

Spacer

(Optional)

STEP 4

Plug the cord into the wall outlet

a) Before connecting power cord, make sure the voltage of the

unit matches with your local voltage.

1 2

Résumé du contenu

Page 1 - Important Safety Instructions

WARNING: TO REDUCE THE RISK OF FIRE OR ELE CTR IC SHO CK, DO NO T REM OVE CO VER (O R BACK). NO USER-SERVICEABLE PARTS INSIDE. REF

Page 2 - Please visit online help at

CLOCK DOES NOT SHOW CORRECT TIME:• There was a power outage. Set the clock again as described in "Setting the Clock".CLEANING THE UNIT• Do

Commentaires sur ces manuels

Pas de commentaire

Rca SPS3200 Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Acoustique Rca SPS3200. RCA SPS3200 User Manual Manuel d'utilisatio

Résumé du contenu

Commentaires sur ces manuels

Produits connexes et manuels pour Acoustique Rca SPS3200